Air Blade Honeypot 2.5"

DESIGN GOALS

When we set out to design the frame, we had a few goals in mind

Modular design for building flexibility

Lighter and less noisy than existing CineWhoop

Sub-250g and still able to provide GoPro picture quality 

No props in camera view

Compatible with a wide variety of electronics

Compatible with Caddx Vista for those who run DJI HD system

FEATURES

Two sets of 20x20 (but only one can be used at a time) and a single central 26x26 layout 

Top-mounted battery design

Compatible with micro FPV camera, like RunCam Hybrid, as well as Caddx Vista

Frame weight (with provided hardware and TPU parts): 60g

Motor mounting pattern: 9mm. Compatible with superman 1404 and smaller motors like 1105-1204 motors. 

Compatible with BetaFPV GoPro Lite V1 Case. A mount compatible with V2 case will be released in the future for you to print. 

The frame comes with 20mm standoff, however you can vary the standoff length to make a slammed build. 

BUILD SUGGESTIONS

The 2.5 inch version Honeypot is designed to be as compact as possible, therefore the space below the bottom plate is designed to take only a 26x26 FC board. If you're building it with the Caddx Vista, an ideal layout would be to have the FC below the bottom plate and the Vista above it, protected by the top plate. 

We recommend running 1204-1404 motors on 450-550mah 3S-4S depending on motor KV. 

INCLUDED

1 x Top Plate (2mm)

1 x Bottom Plate (2mm)

2 x Front-Back Plate (2mm)

2 x Left-Right Plate (2mm)

2 x Connecting Guard Plate (2mm)

8 x Guard Plate (2mm)

1 x Hardware pack

1x TPU Naked GoPro Mount (BetaFPV GoPro Lite V1)

1x TPU GoPro Mount Base